🔥 Furnace Repair London Ontario — $175 Flat • 24/7 Zero Surcharge • All Brands • TSSA Certified Gas & LP/Propane
Ignitor replacement same-visit • Control board $325–550 • Blower motor $350–550 • Tune-up $149 • 150+ five-star reviews • BBB A+
Furnace Repair
London Ontario.
$175 Flat. 24/7.
All Brands. TSSA Certified.
Furnace repair in London Ontario — $175 flat service call, 24/7, zero after-hours surcharge. Abdullah Ghzail is TSSA certified for natural gas and LP/propane. Every furnace repair call in London Ontario is Abdullah personally — no dispatch rotation, no subcontractors.
The most common furnace repair in London Ontario is ignitor failure — part is always on the service vehicle, same-visit fix in most cases. All brands repaired: Goodman, Lennox, Carrier, Bryant, York, KeepRite, Trane, Rheem, Ruud, Napoleon, Amana, American Standard, Armstrong, Kepler, Midea, and all others.
Diagnosis + standard labour, any hour, any day$175
Most common repair • Part on vehicle • Same-visit$215–240
Furnace lights briefly then shuts off$175–200
Inducer runs, no ignition$195–280
Error codes, intermittent operation$325–550
No airflow or bearing noise$350–550
Prevents most winter breakdowns$149
Signs Your Furnace Needs Repair
in London Ontario
London Ontario winters regularly drop below −15°C. A furnace failure in a January cold snap is dangerous. Most failures give warning signals days or weeks before complete breakdown — and a $175 service call that catches a failing ignitor is far better than an emergency at 2 AM.
Furnace is completely silent or the inducer runs but no heat. Before calling: replace your air filter and check the thermostat is set to Heat. If those are fine, this is almost always ignitor failure ($215–240, same-visit fix) or a failed pressure switch ($195–280). Call (647) 550-4220.
Furnace ignites briefly — you hear the burners fire — then it shuts off after a few seconds and locks out. This is almost always a dirty flame sensor. The sensor can’t confirm the flame and shuts the furnace off on safety. Flame sensor cleaning is $175–200 and is a same-visit fix. Call (647) 550-4220.
Furnace runs for 2–5 minutes, shuts off, immediately restarts. First: replace your air filter. A blocked filter causes overheating, triggering the high-limit switch. If a new filter doesn’t fix it within one cycle: call (647) 550-4220. Short-cycling stresses the heat exchanger and compressor.
Modern furnaces flash error codes on the control board LED. Count the blinks and check the chart inside the furnace door. Common codes: 3 flashes = pressure switch, 4 flashes = open high-limit, 7 flashes = gas valve. Text or call (647) 550-4220 with the blink count — phone pre-diagnosis confirms likely cause before arrival.
Furnace runs but rooms don’t reach temperature, or some rooms are cold. Check your air filter first. If the filter is clean: blower motor losing efficiency ($350–550), partially blocked heat exchanger, or refrigerant issue in a heat pump system. Call (647) 550-4220.
Banging on startup: delayed ignition — gas builds up before igniting. Shut off and call. Screeching: blower motor bearing failure — will fail completely soon ($350–550). Rumbling from burner: dirty burners or cracked heat exchanger. Don’t ignore furnace noises. Call (647) 550-4220.
Every Furnace Repair We Do
in London Ontario
$215–240 All-In
The ignitor is a small ceramic element that glows hot enough to ignite the gas burners. When it fails, the inducer motor runs normally but the furnace never fires — no heat. This is the single most common furnace repair in London Ontario.
Ignitors for Goodman, Lennox, Carrier, Bryant, York, KeepRite, Trane, and all major brands are stocked on the service vehicle. Most ignitor replacements are same-visit fixes — call in the morning, heat on by noon. Cost: $215–240 all-in including the $175 service call.
$325–550 All-In
The control board is the furnace’s brain — it sequences every stage of the heating cycle. When it fails, the furnace may produce random error codes, fail to start certain stages, or shut down mid-cycle. Control board replacement is $325–550 depending on brand and model.
For furnaces 15+ years old, Abdullah always provides the option to replace the furnace alongside the repair quote — a $325–550 control board repair on a 20-year furnace is worth comparing to a new Goodman GR9T96 at $3,500 all-in installed.
$350–550 All-In
The blower motor circulates heated air through your ductwork. When it fails: furnace fires but you feel little or no air from the vents, or the motor makes a screeching or grinding noise (bearing failure). Blower motor replacement is $350–550 all-in depending on motor type and brand.
Screeching from the blower is a warning sign that the bearings are failing — don’t ignore it. When the motor seizes, it can also trigger high-limit shutdowns and stress the heat exchanger. Call (647) 550-4220 when you hear the noise, before it fails completely.
$350–550 All-In
The inducer motor vents combustion gases before and during burner operation. On a high-efficiency furnace (96%+ AFUE like the Goodman GR9T96), if the inducer fails the pressure switch won’t close and the heating cycle never starts — you’ll hear silence when the thermostat calls for heat.
Inducer bearing noise — a high-pitched hum or rattle at the start of each cycle — is a pre-failure warning. OEM replacement inducers are stocked for major brands. Cost: $350–550 all-in. Call (647) 550-4220.
$175–280 All-In
Pressure switch ($195–280): Confirms inducer is creating proper draft before allowing ignition. A failed pressure switch lets the inducer run normally but the furnace never proceeds to ignition. Can also be triggered by a blocked condensate drain on a high-efficiency furnace.
Flame sensor ($175–200): A small rod in the burner that confirms flame is present. Carbon buildup on the sensor causes the furnace to shut off seconds after lighting (lockout). Cleaning or replacement is one of the fastest and lowest-cost repairs. Call (647) 550-4220.
$149 — Written Report
The $149 annual tune-up prevents the majority of winter furnace breakdowns. Included: burner cleaning, heat exchanger visual inspection, ignitor resistance test (catches failing ignitors before they fail on a cold night), flame sensor cleaning, flue inspection, filter check, safety limit testing, gas pressure measurement, written report.
When to Repair vs Replace
Your Furnace in London Ontario
- ›Furnace under 15 years old
- ›Repair under $600
- ›Ignitor, flame sensor, pressure switch failure on any age furnace
- ›Blower motor on furnace under 12 years old
- ›Control board on furnace under 12 years old
- ›Cracked heat exchanger — replace immediately
- ›Furnace 20+ years old with any major part failure
- ›Control board on a 15+ year furnace ($325–550 repair)
- ›Second major repair in two seasons
- ›Repair exceeds 30% of replacement cost
If replacement is the right decision, Goodman GR9T96 two-stage starts at $3,500 all-in installed. Abdullah quotes both options — written repair quote and written replacement quote — at every service call where replacement is worth considering.
Why London Ontario Homeowners
Choose Hawana for Furnace Repair
Most London Ontario furnace failures happen in January and February, at night, on weekends. $175 flat any hour, any day. No “emergency rate.” No weekend surcharge. The same rate at 11 PM Saturday as 10 AM Wednesday.
Ignitors, flame sensors, pressure switches for Goodman, Lennox, Carrier, Bryant, York, KeepRite, and all major brands are stocked on the service vehicle. Most ignitor and flame sensor repairs are same-visit fixes — no second appointment, no waiting for parts.
Written quote before any part is ordered. Repair and replacement (Goodman GR9T96, Kepler, Midea) options both quoted when relevant. Your approval required before any work proceeds.
Ontario law requires TSSA certification for gas furnace work. Abdullah is TSSA certified for both natural gas and LP/propane. Certification records available on request. No unlicensed subcontractors.
$175 flat, ignitor $215–240, control board $325–550. All published. No “call for a quote.” You know the price range before Abdullah arrives. No invoice surprises.
Every London Ontario furnace repair call is Abdullah personally. He remembers your furnace model, its history, and is personally accountable for every diagnosis and repair. No rotating staff, no subcontractors.
Every Furnace Brand Repaired
in London Ontario
Same $175 flat service call for every brand. TSSA certified gas & LP/propane. Written quote before any work.
Abdullah Ghzail — Furnace Repair
London Ontario Since 2018
Abdullah Ghzail founded Hawana HVAC in 2018 and has repaired furnaces across all London Ontario neighbourhoods ever since. Every furnace repair call in London Ontario is Abdullah personally — no dispatch rotation. He knows the specific furnace challenges of each London neighbourhood: the aging Lennox and Carrier systems in Old North’s older homes, the Goodman and KeepRite units in south-end builds, and the LP/propane systems on rural properties.
What London Ontario Homeowners Say
About Hawana Furnace Repair
“Furnace stopped working at midnight in January — minus 18 outside. Called Hawana, Abdullah arrived in under 90 minutes. Ignitor failure, part was on the truck. Heat back on by 1:30 AM. $175 service call plus $65 for the part. No midnight surcharge, no surprise. Exactly what the website said it would cost. Can’t recommend enough.”
“Control board failure on our 14-year-old furnace. Abdullah gave me both options in writing — $480 board repair or $3,500 all-in for a new Goodman GR9T96. He was completely honest that at 14 years the repair made sense. Repaired same day. Invoice matched the quote to the dollar. The $175 flat rate is genuinely flat. No fees added.”
“Rural property on propane — two companies said they don’t work LP systems. Hawana came next morning. Abdullah is TSSA certified for propane, diagnosed a faulty gas valve, replaced it same day. $175 flat, written quote, zero propane surcharge. Finally an HVAC company that actually does what the website says.”
Furnace Repair Across
All London Ontario Neighbourhoods
Furnace Repair London Ontario
Frequently Asked Questions 2026
Furnace Repair London Ontario
$175 Flat • 24/7 Zero Surcharge • All Brands • TSSA Certified
Ignitor same-visit fix in most calls. Control board, blower motor, inducer motor, pressure switch — all brands repaired. Annual tune-up $149. New Goodman GR9T96 from $3,500 when replacement is the right call. 150+ five-star reviews. BBB A+.
Hawana HVAC Solutions provides furnace repair in London Ontario and surrounding areas. TSSA certified gas technician Abdullah Ghzail. Natural gas and LP/propane certified. $175 flat 24/7 zero after-hours surcharge. Founded 2018. 150+ five-star Google reviews. BBB A+ rating. Bilingual English and Arabic. Furnace repair: ignitor $215–240, flame sensor $175–200, pressure switch $195–280, control board $325–550, blower motor $350–550, inducer motor $350–550. Annual tune-up $149. New furnace installation: Goodman GMS96 single-stage $3,400, Goodman GR9T96 two-stage $3,500, Kepler furnace and Midea furnace available on request. All A2L-compatible parts available for modern furnace repairs. All brands: Goodman, Lennox, Carrier, Bryant, York, KeepRite, Trane, Rheem, Ruud, Napoleon, Amana, American Standard, Armstrong, Kepler, Midea, and all others. Furnace repair London Ontario 2026. Hawana HVAC Solutions 670 Millbank Dr London ON N6E 1S2 telephone 647-550-4220.
